Fabric Storage Bin

I went to a ladies bric-a-brac sale at the weekend and the stall at the entrance was doing a very brisk trade soI decided to have a look. Basically the were selling fabric Storage Bins of off sizes, I thought they were fun but, expensive. I was sure that they couldn't be that difficult to make and that I had all I needed already and I was right.

This storage bin took about 3 hours to make from working out how to do it and finishing it and was made from scraps and leftover material I already had. It's measures 25cm across, just right for keeping my knitting in - a felted bag which I'll share with you at a later date.

You can make them any size so I'm not going to put the measurements in but how to work out the sizes of the 2 pattern pieces you'll need:

Pattern Pieces

The Base: a circle, measuring Xcm across (in this case 25cm)

The Side: a rectangle: side 1, measuring the desired height including (in this case 30cm) turnover. Side 2, measuring the diameter of the base x 3.14 (25 x 3.14=78.50cm)

Material

Exterior material, cut 1 x base, 1 x the side rectangle
Interior material, cut 1 x base, 1 x the side rectangle
Interfacing, cut 2 of each. - I used a fairly heavy weight interfacing, to help stabilise the sides

Instructions:

Cut out all the pieces and iron on the interfacing on the wrong side of all the pieces. Starting with the exterior material, with right sides facing sew down the side seam and clip back the interfacing. If you don't it might get a bit lumpy and thick.

Carefully pin the base to the tube, again right sides together, you might find it easier to tack (loosely sew) them together before slowly and carefully sewing the pieces. Clip back the interfacing and snip small v's into the edge of the circle being careful not to cut into the stitching.

Repeat with the interior pieces.

No put the 2 pieces inside each other, right sides together, lining up the seams and sew the top of the storage bin together leaving a gap so that you can turn it the right way round.

Don't forget to clip the interfacing back before you turn it the right way round, once you've done that top-stitch the top edge. This also closes the gap in the top seam. Don't be tempted to miss the top-stitching, it really makes a difference to the finish of the whole thing.


Enjoy.